 1)
Level a 3’x 4’ area.
2) Add sand if ground is unfriendly.
3) Set tank.
4) Remove bottom lip from blocks (see
lip removal).
Set base row of blocks.
|
 1)
Level tank and base row of blocks in all directions.
2) Wrap block around unit paying special attention to fitting front
blocks tightly against the front lips.
3) This will leave a 1” air space between tank and block.
Blocks can be spaced a little bit around backside if needed to fit
different materials.
|
 1)
If the tank and the base are leveled and set correctly, everything falls
into place perfectly.
2) Start second course with split blocks if desired (see
splitting blocks).
3) Stack blocks and fit under top lip. (Tank can be raised at this
point if necessary to fit material perfectly).
For info on how to raise or lower your tank, see installation
tip # 6.
|
